Connection Cable - MFD28/32 Gen2 to OBD2 - Pin1 KL15 + K-Line (VAG)
CANchecked
Kunde anmeldelser
Hjelp andre med å velge riktig. Bli den første til å skrive en anmeldelse!
Skriv en anmeldelseCANchecked Display OBD 2 Cable Kit for MFD28 / MFD32 / MFD32S specifically for VW/Audi and BMW
With the OBD 2 Cable Kit, you willl get the perfect accessory for CANchecked DisplayMFD28 / MFD32 / MFD32S displays. This OBD 2 cable allows you to display OBD 2 values on your display.
Finally, the OBD2 cable for CANchecked Displays is available! Installation takes just a few minutes, and you can conveniently read all OBD 2 values on your display. Even stored fault codes are displayed!
Simply use the pre-configured OBD TRI files to easily display the values. This way, you have all the important information right at your fingertips.
The package includes:
- OBD connector with a 2-meter (6ft 6in) cable for connection to MFD28/MFD32/MFD32S
The following pins are connected from the OBD connector to the display: Terminal 15 (Pin 1), Ground (Pin 4+5), Can High (Pin 6), Can Low (Pin 14)
Our OBD 2 Cable Kit supports all OBD 2 values output by the control unit. You can display up to 128 values on your display, allowing you to gather even more information about your vehicle.
----------------
Guider og Info
| Bilmärke | VAG |
Vær den første til å skrive en anmeldelse om dette produktet!
Din kommentar:
For å legge inn en anmeldelse, må du være innlogget.
Verktøy
